Goldsby Roofing With the Scope Named First
Roof replacement, roof repair, leak tracing and gutters for homes in Goldsby, Norman, Newcastle and Washington. Every flashing and boot is named before a shingle comes off.
Name the scope with us — (000) 000-0000Four jobs, each with its own written scope
A call about a Goldsby roof usually starts as one of four jobs. Replacement is a full tear-off and a new roof system. Repair is the failed piece only: a shingle run, a valley, a pipe boot, a stretch of flashing, or a soft spot of decking. Leak tracing follows the water back to the opening instead of treating the stain on the ceiling. Gutters and downspouts move that water off the wall and away from the foundation.
The scope is a list, not a slogan. It names the slope, the layers coming off, the underlayment, the flashing pieces, the boots, the ridge, and what happens if the decking underneath is soft. You hear that list on the phone and again on the roof before anyone pulls a shingle. If the visit shows a different failure, the list changes in writing before the work changes.
Roof Replacement
Tear-off, deck check, underlayment, flashing and a new shingle system, listed before the first course comes off.
Read the replacement scopeRoof Repair
The failed piece only — a run of shingles, a valley, a boot or a flashing joint — with the rest of the roof left alone.
Read the repair scopeRoof Leak Repair
The stain is the symptom. The visit traces the water to the opening and names that opening before any patch.
Read the leak scopeGutters & Downspouts
New runs, outlets and downspouts so water leaves the eave and does not sit against the wall.
Read the gutter scopeWhy the scope is the product
The work you can see is the last step. The useful part is the list that comes first: what comes off, what stays, what gets replaced, and what the crew will not guess at once the deck is open. That list is how a Goldsby job stays the job you agreed to. If a sheet of decking is soft, the list grows by that sheet before the shingles go back down. If a boot was not on the original list and the tear-off shows it is cracked, it gets added in the same way. You are not asked to discover the change from a bill after the crew has left.
The scope is written before a shingle moves
Flashing, boots, valleys, ridge and underlayment are named on the list. A change on the roof becomes a change on the list before the crew keeps going.
Soft decking is called out, not covered
If a sheet is soft, the scope says which sheet and that it gets replaced. The new shingles do not go down over a deck that will not hold a nail.
Nails are swept before the crew leaves
Tear-off throws nails into the yard and the driveway. A magnet pass is part of the job, not a favor added at the end.
One person stays on the job
The person who wrote the scope is the person you call when a question comes up during the tear-off. You are not handed to a different desk.
How a Goldsby roof job actually runs
Five steps, in this order. None of them is a form on this website. The phone call is the start, and the written scope is what you agree to.
- 01
You call and describe the roof
Age of the shingles, where water showed up, and whether you want a repair or a full replacement. We say which of the four jobs it sounds like.
- 02
We walk the roof and name the pieces
Slopes, flashing, boots, valleys and any soft deck. The scope is the list of those pieces, not a single lump price with no contents.
- 03
You approve the list
Nothing is torn off until the list is the list you want. If you want a repair and the roof can take a repair, that is the job.
- 04
The crew does that list
Tear-off or repair, then underlayment, flashing and shingles as written. A soft deck stops the job long enough to add that sheet to the scope.
- 05
The yard is cleared
Debris goes, and a magnet picks up nails. You get the same person on the phone if something in the list needs a second look.
Goldsby and the towns next door
The crew works Goldsby in McClain County, and the same scope rules apply in Norman, Newcastle, Washington and Noble. A job in town and a job a few miles out get the same written list. The towns are where we drive. The product is still the scope.
- Goldsby
- Norman
- Newcastle
- Washington
- Noble
Questions people ask before a shingle moves
What changes the price of a roof replacement?
Layers already on the deck, how much decking is soft, the flashing and boots that have to be rebuilt, the pitch, and how the debris has to leave the yard. The scope names those items. We do not publish a dollar figure on this site because two roofs with the same shingle can have different decks.
Which shingles do you put on?
Architectural asphalt shingles, with the underlayment and starter course named in the scope. The brand on the bundle is part of the list you approve, so you are not surprised by what shows up on the truck.
Do you pull a permit?
When the city or the county requires a permit for the tear-off, the permit is part of the job and it is named in the scope. You are not left to file it yourself after the crew has started.
What happens on the visit?
Someone walks the roof, looks at the deck from the attic when the attic can be entered, and writes the pieces that failed. You get that list before any shingle is pulled. The visit is the scope, not a separate product.
Does the roof need ventilation work?
If the ridge or the intake is blocked, the scope says so and includes the ridge vent or the intake that has to be opened. A new shingle layer on a roof that cannot breathe is a short-lived roof.
Who is actually on the roof?
The crew that starts the tear-off is the crew that finishes the nailing and the magnet pass. You keep one person to call, the same person who wrote the scope.
Bring the stain, the age of the roof, or both
Tell us whether water is coming in, whether the shingles are simply tired, or whether the gutters are dumping water against the wall. We will say which job it is and what the scope has to name.